How to replace the screen of the iPhone 4 [iPhone Tutorial]

As nobody is immune to awkwardness and the Retina display on iPhone 4 is fragile, here's a tutorial to replace the screen of the iPhone 4 .

So it can seem complex, but with patience and by following this step by step guide , you will earn money doing it yourself replacing the screen of your smartphone with price is not excessive.

To replace the screen on your iPhone 4, you need:

• screwdriver Pentalobe

• a screwdriver

• a plastic spatula to pry

• one screen iPhone 4 black or white iPhone 4 screen available on the website MoniPomme.com to € 39.99 (15% coupon at end of article)

Council : Note the location of each screw, there are different lengths!

Tutorial: iPhone 4 screen replace its

• remove the sim card and iPhone Support
• Remove the 2 screws Phillips or Pentalobe (according to the age of your iPhone 4)

• Drag up the rear of the iPhone and remove

• Remove the Phillips screw fixing 2.5 mm connector of the battery (there may be two screws in some models) and gently lift the connector

• Lift and remove the battery using the plastic tab: there is glue, gradually pull 

• Remove the following two screws that hold the cover in steel:
  • 1.2 mm Phillips screws
  • 1.6 mm Phillips screws
  
• Carefully lift the connector from the motherboard: take care of this jack can tear

• Lift the lower antenna connector from its holder on the system board

• Remove the Phillips screw 1.9 mm

• Remove the five screws around the antenna Wifi
  • 2.3 mm Phillips screws
  • 2 x 1.6 mm Phillips screws
  • Phillips 1.4 mm
  • 4.8 mm Phillips screws

Advice : when reassembling start with screw 4.8 mm to 2.3 mm and to avoid placing it elsewhere and damage the LCD screen!

• Slightly lift the antenna Wi-Fi on the edges

Tip: When reassembling degrease well Wifi antenna for not interfering.

• Lift the socket of the camera and remove the rear camera

• Remove the white sticker (control humidity)
• Remove the 2.4 mm Phillips screw that holds the plastic tab

• Gently pry the 5 connectors on the motherboard

• Use a small screwdriver to remove the retaining arm near the headphone jack

• Carefully remove the motherboard iPhone 4, taking care not to damage the pin marked in red

• Remove the screw holding the 2.4mm speaker and remove

• Remove the two screws securing the vibrator:
  • 6 mm Phillips screws
  • 1.4 mm Phillips screws
• Remove the vibrator

• Remove the 1.5 mm Phillips screws next to the headphone jack

• Remove the 3 screws 1.5 mm volume buttons on the iPhone, keep the washers!

• Remove the screw of 1.5 mm close to the microphone

• Remove the screws of 1.5 mm remaining close to the water side of the dock connector SIM card

• Insert a plastic spatula to gently lift the glass and remove the whole constituting the screen of the iPhone 4

Council : attention the Home button and paste that can be damaged remain

Congratulations, you just remove the screen of your iPhone 4 to reassemble just follow this tutorial backwards.

If you do not feel capable of replacing your screen, you can send your smartphone service repair iPhoneSite MoniPomme.com .

You can enjoy 15% discount on the price of iphone 4 screen with promo code INFOIDEVICE4 (code valid until February 4, 2013)