As nobody is immune to awkwardness and the Retina display on iPhone 4 is fragile, here's a tutorial to replace the screen of the iPhone 4 .
So it can seem complex, but with patience and by following this step by step guide , you will earn money doing it yourself replacing the screen of your smartphone with price is not excessive.
To replace the screen on your iPhone 4, you need:
- screwdriver Pentalobe
- a screwdriver
- a plastic spatula to pry
- one screen iPhone 4 black or white iPhone 4 screen available on the website MoniPomme.com to€ 39.99 (15% coupon at end of article)
Council : Note the location of each screw, there are different lengths!
Tutorial: iPhone 4 screen replace its
- remove the sim card and iPhone Support
- Remove the 2 screws Phillips or Pentalobe (according to the age of your iPhone 4)
- Drag up the rear of the iPhone and remove
- Remove the Phillips screw fixing 2.5 mm connector of the battery (there may be two screws in some models) and gently lift the connector
- Lift and remove the battery using the plastic tab: there is glue, gradually pull
- Remove the following two screws that hold the cover in steel:
- 1.2 mm Phillips screws
- 1.6 mm Phillips screws
- Carefully lift the connector from the motherboard: take care of this jack can tear
- Lift the lower antenna connector from its holder on the system board
- Remove the Phillips screw 1.9 mm
- Remove the five screws around the antenna Wifi
- 2.3 mm Phillips screws
- 2 x 1.6 mm Phillips screws
- Phillips 1.4 mm
- 4.8 mm Phillips screws
Advice : when reassembling start with screw 4.8 mm to 2.3 mm and to avoid placing it elsewhere and damage the LCD screen!
- Slightly lift the antenna Wi-Fi on the edges
Tip: When reassembling degrease well Wifi antenna for not interfering.
- Lift the socket of the camera and remove the rear camera
- Remove the white sticker (control humidity)
- Remove the 2.4 mm Phillips screw that holds the plastic tab
- Gently pry the 5 connectors on the motherboard
- Use a small screwdriver to remove the retaining arm near the headphone jack
- Carefully remove the motherboard iPhone 4, taking care not to damage the pin marked in red
- Remove the screw holding the 2.4mm speaker and remove
- Remove the two screws securing the vibrator:
- 6 mm Phillips screws
- 1.4 mm Phillips screws
- Remove the vibrator
- Remove the 1.5 mm Phillips screws next to the headphone jack
- Remove the 3 screws 1.5 mm volume buttons on the iPhone, keep the washers!
- Remove the screw of 1.5 mm close to the microphone
- Remove the screws of 1.5 mm remaining close to the water side of the dock connector SIM card
- Insert a plastic spatula to gently lift the glass and remove the whole constituting the screen of the iPhone 4
Council : attention the Home button and paste that can be damaged remain
Congratulations, you just remove the screen of your iPhone 4 to reassemble just follow this tutorial backwards.
If you do not feel capable of replacing your screen, you can send your smartphone service repair iPhoneSite MoniPomme.com .
Hey I my friends I tell you something can you give me answer please A few months ago I laid my iPhone4 on the hood of a car in the garage, where it slid off and hit the concrete floor, face down, hard. I felt a wave of adrenalin and regret when I picked it up and found the glass screen shattered. The damage was mostly on the top of the screen where much of the glass was fractured into many tiny shards, but all the pieces remained in place. To my surprise, I was relieved to find out that the LCD touch screen still worked perfectly.
ReplyDeleteiphone 4 screen replacement
This comment has been removed by the author.
ReplyDelete